EP2809-0021 Beckhoff
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The EP2809-0021 is a digital input module from Beckhoff, part of the EP Digital Input Modules series. It features 16 outputs and uses EtherCAT protocol, with a nominal output voltage of 24 V DC and supports a maximum total output current of 4 Amps. The module is housed in PA6 polyamide, offers ingress protection up to IP65/IP66/IP67, and allows variable installation positions.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The EP2809-0021 belongs to the EP Digital Input Modules series manufactured by Beckhoff. It is an IP-rated field-mountable block that converts discrete sensor and actuator signals into data for an EtherCAT network, allowing distributed I/O to be located close to machinery. Within an automation architecture, the module provides a compact, sealed interface between 24 V DC control power and the controller, minimizing cabinet wiring while maintaining signal integrity. This layout also lets machine builders place output connections nearer to field devices, which helps shorten cable runs across the machine.
Communication with higher-level controllers is handled through the EtherCAT real-time protocol, so process data for the module’s 16 outputs is updated deterministically with every network cycle. Each channel can deliver up to 0.5 A per channel, 4 A in total, which is sufficient for small solenoids, indicator lamps, or relay coils. The outputs switch the machine supply rail directly because their rated level matches the 24 V DC nominal output voltage. For outdoor or washdown placement, the enclosure carries a combined protection rating of IP65/IP66/IP67, blocking dust ingress and resisting water jets as well as temporary immersion. That operating method suits applications where distributed loads must respond in step with the controller rather than through slower non-real-time signaling.
The upstream wiring uses a shielded 2 × M8, 4-pin bus interface, reducing electromagnetic noise and enabling daisy-chain topology without additional junction boxes. A slim profile of 60 × 126 × 26.5 mm allows the unit to fit on narrow machine frames, while the light yet durable PA6 polyamide housing withstands vibration and chemical splashes. Output stages are individually short-circuit proof, so a fault on one load does not disable the remaining channels. Auxiliary sensor power at 24 V DC and 0.5 A is provided through separate pins, and GND_S is isolated from GND_P to help reduce ground loops. The module can be mounted in any orientation, supports ohmic, inductive, or lamp loads, and offers keyed M8 connectors for both power pass-through and three-pin load wiring.
