Product Description:

The CP7032-1002 is an operator panel produced by Beckhoff within the CP Panel PC Systems series. It is supplied over a single CP-Link connection that carries both power and video, allowing the unit to be mounted up to the maximum link distance from the control cabinet without local mains wiring. Used as a human-machine interface, the panel presents process data to operators and forwards touch input or keyboard commands back to the automation controller through the same link, minimizing cable count on the machine frame.

The aluminum front bezel carries a protection rating of IP65, so the screen surface resists dust ingress and low-pressure water jets during washdowns. Information is displayed on a 15 in diagonal screen that uses TFT technology, giving wide viewing angles and stable color reproduction for status graphics. The housing spans 483 mm in width, which corresponds to a standard 19-inch rack dimension and simplifies enclosure integration. Depth is limited to 28.5 mm; this shallow profile leaves clearance behind the panel for airflow and compact wiring bends. Two CP-Link cables terminate on BNC connectors labeled A and B, separating power and video return paths to reduce signal crosstalk and preserve display clarity over the full bus length.

The rear I/O block is sealed to IP54, so the BNC leads can be disconnected without exposing internal electronics to sprayed liquids. Total panel height is 410.2 mm, a figure that must be considered when selecting door cutouts or swing mounting arms. When flexible mounting is required, the permitted CP-Link run of 100 m supports remote installation on large production lines. The panel has 4 pre-drilled mounting bosses that provide fixed anchoring points and transfer touch forces into the machine frame without distorting the narrow chassis.