Product Description:

The AM3024-0C00-0000 belongs to the AM Synchronous Servo Motors series produced by Beckhoff. As a compact synchronous servo motor, it provides controllable torque and speed for positioning axes, pick-and-place gantries, and general motion modules in automated machinery. Used with a compatible Beckhoff drive, it supports precise motion control during repetitive industrial cycles. Rotor magnets work with electronic commutation to produce the responsive servo behavior expected in packaging, handling, and light assembly equipment.

This model mounts to a machine frame with a 58 mm square flange, which gives it a compact installation footprint. Cabling is routed through the factory-fitted rotatable angular connector, helping the motor fit into tight spaces where cable direction matters. Rotor position is reported by a two-pole resolver, allowing the controller to close the feedback loop at high speed even in electrically noisy environments. The mechanical output uses a smooth shaft, so torque is transferred through clamp couplings or press-fit pulleys without keyway stress. Because the motor is supplied without a holding brake, any load restraint during power-off conditions must come from an external locking device or drive-controlled torque.

The electrical design uses winding code C, which indicates a coil set intended for nominal drive voltages commonly used with Beckhoff AX5xxx inverters. Physical depth follows overall length code 4, placing the motor in the fourth stator stack of the AM30 frame and setting its continuous torque class. It is listed as a standard motor series type, so optional high-inertia rotor features and special coatings are not included on this unit. The motor also uses the standard version, which corresponds to the default paint and bearing selection for this configuration.