ECNT43-0 B & R Automation
Wake Industrial LLC is not an authorized distributor of this product.
The B & R Automation ECNT43-0 is a power supply from the ECN PLC Power Supplies series featuring a nominal input voltage of 24 VDC and a total power output of 100 W. It has a current requirement of 7 Amps and uses a switching supply topology with electrical isolation. The ECNT43-0 includes extended diagnostics and a 10 A 250 V slow blow fuse rating.
Internal Product Review
The ECNT43-0 is a B & R Automation PLC power supply with a 24 VDC nominal input and a switching topology. Electrically isolated supply architecture and 100 W total power output support stable integration in control systems. Extended diagnostics adds valuable service visibility, making this unit a strong choice for dependable PLC power distribution.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
B&R Automation manufactures the ECNT43-0 supply module for the ECN PLC Power Supplies series. This unit is a regulated power supply that furnishes stabilized low-voltage rails required by ECN programmable logic controllers and their connected field I/O modules. By converting a 24 V battery or plant bus to multiple isolated outputs, it supports consistent controller operation and sensor signaling in automated production cells. Multiple regulated rails allow one module to feed controller electronics and associated interface circuits from a single compact unit.
The input section is rated for a nominal 24 VDC feed and can draw up to 7 A when the secondary rails are fully loaded. A bulk reservoir of 6000 µF filters incoming ripple, and an additional 6800 µF/35 V capacitor helps the module ride through brief input dips. The extra capacitance helps maintain stable output conditions during short disturbances on the supply line. Dielectric strength across the primary-to-secondary barrier reaches 4000 Vrms, and the converter is electrically isolated to help prevent ground loops between the PLC backplane and field wiring. Built-in diagnostics report supply temperature, fuse status, and overload history to the controller.
The output stage uses a switching topology to generate regulated +15 V, +8 V, and −30 V rails. The +15 V rail can supply up to 100 W, while the +8 V rail and −30 V rail can deliver 65 W and 30 W respectively; combined loading must remain within the module’s overall limit of 100 W. Relay contacts tied to these rails can be loaded up to 2000 VA or 150 W without exceeding thermal limits, which allows the module to support relay-connected loads as well as low-voltage PLC circuits. The protective element is a front-mounted 10 A 250 V slow-blow fuse, and the assembly stays compact because it does not require a three-phase capacitor.
