Product Description:

The 8ECM0010.1523C-0 is a pre-assembled hybrid cable manufactured by B&R Automation for the ACOPOS P3 Cables series. Intended for servo drive installations, the assembly carries three-phase power and low-level feedback signals between ACOPOS P3 inverters and their motors, enabling coordinated motion control across automated production lines. An 8-pin female SpeedTec connector in size 1.5 is factory-installed, which helps simplify routing in control cabinets and on moving machine sections.

Its total length of 10 m supports routing through medium-sized machines without extensions. The copper conductors can carry up to 64.6 A when mounted on a wall, making the cable suitable for the continuous current drawn by typical P3 axes. Insulation is rated for a maximum operating voltage of 1000 VAC, so the cable can be used with high-voltage drive connections. The molded interface and overmolded jacket meet IP66/67 protection, sealing the connection against dust and high-pressure washdown. For cable-chain service, the construction supports continuous travel speeds of up to 300 m/min in high-cycle handling equipment.

During motion, the polyurethane jacket helps limit abrasion, and the minimum moving bend radius is 154 mm. For fixed installation, a single bend may be formed to 62 mm without damaging the cores. Conductor sizing follows 4× 10 mm² + 2× 0.75 mm² + 2× 1.5 mm², which separates the power cores from the signal pairs to reduce crosstalk. The 8-contact SpeedTec plug mates with a quarter-turn lock for a secure connection. The cable has a wire-to-wire test potential of 4 kV, and its insulation resistance remains above 500 MΩ·km. The assembly also withstands drag-chain acceleration up to 50 m/s², while the TPU outer jacket helps maintain reliable performance during repeated motion.