Product Description:

The 8ECM0006.1031C-0 cable is produced by B & R Automation and is part of the ACOPOS P3 Cables series. It links ACOPOS P3 servo drives to field-mounted motors, carrying both power and low-level feedback signals needed for closed-loop motion in industrial automation systems. A shared outer sheath houses separate power cores and twisted signal pairs, so one assembly can route both functions while keeping the cable layout compact. This combined design reduces the need for separate motor and feedback runs and helps keep moving cable packages manageable on dynamic axes.

The conductor set is 4x 0.75 mm² + 2x 2x 0.34 mm², which means four power conductors are paired with two shielded signal pairs for feedback transmission. The cable is rated for 5,000,000 flex cycles, making it suitable for repeated motion in cable tracks. During operation, the jacket is rated for up to 1000 VAC, and each core may carry a continuous current of 13 A under wall-mounted conditions. When connected, the coupling has a protection level of IP66/67, which helps resist dust and high-pressure water on washdown machinery. The separation between the power conductors and signal pairs helps reduce interference that could disturb low-level feedback signals during axis movement.

An 8-pin female Series 915 power connector terminates the cable, providing the contact layout needed for the power and signal conductors. Dielectric strength is verified with a wire-to-wire test voltage of 4 kV, and insulation resistance is rated at 500 MΩ-km minimum for stable isolation over long runs. The power conductors have a maximum loop resistance of 26.7 Ω/km, which supports predictable voltage drop calculations across extended cable lengths. Stable insulation and controlled conductor resistance are important where servo drives must preserve accurate supply and feedback performance over longer runs.