Product Description:

The 8CCH01X2.11110-1 hybrid cable is produced by B&R Automation as part of the 8CC ACOPOSremote Hybrid Cables series. It combines motor power, a 24 V auxiliary supply, and real-time Ethernet pairs into one flexible lead for ACOPOSremote drive modules used in distributed motion systems. This combined layout reduces separate cable runs along moving axes and helps keep routing compact between cabinet-mounted controls and field-installed drive components. With a mass of 0.42 kg, the cable adds minimal moving load while maintaining reliable power and data transfer.

The cable is supplied in a fixed length of 1.2 m, which suits short inter-rack or junction-box runs. Its 2x2x0.34 + 4x0.75 + 5x2.5 mm² conductor set separates Ethernet pairs from power cores and supports simultaneous control and motor current. A PUR jacket resists oil, and the connection reaches IP65 when locked, allowing use on washdown machinery. With a minimum bend radius of 150 mm, the cable can move inside standard drag chains. Tinned-copper braid with foil shielding helps limit EMI, and an insulation resistance of 500 MΩ·km reduces leakage. The 15-pin female TYCO connector supports 20 mating cycles and carries up to 100 V on the data cores.

For high-speed gantries, the assembly survives at least 5,000,000 bending cycles while operating at carrier velocities up to 300 m/min and acceleration peaks of 50 m/s² without conductor fatigue. The power bundle supports 29.1 A of continuous tray current and withstands up to 1000 V, allowing direct connection to the ACOPOSremote DC link. A low-loss dielectric helps preserve signal integrity over the low-voltage control pairs, and nickel-plated contacts maintain stable resistance during vibration. The cable is suited for continuously moving automation axes where both electrical performance and flex life must remain consistent.