Product Description:

The 8CCH01X1.11110-1 hybrid cable is produced by B&R Automation within the 8CC ACOPOSremote Hybrid Cables series. Designed for distributed servo axes, the assembly combines power conductors, DC link lines, and signal pairs in a single jacket so a drive module can be linked to an ACOPOSremote unit with one run. By carrying power and feedback channels together, the cable simplifies machine wiring and maintains deterministic communication in automated packaging, material handling, and assembly lines while remaining suitable for motion carriers subject to continuous movement.

The conductor layout is 5×2.5 mm² + 2×2×0.75 mm² + 2×2×0.34 mm², meaning five power cores and four twisted pairs share the same sheath. This arrangement separates motor supply, DC bus, and communication lines while keeping the overall diameter to 14.6 mm ±0.4 mm. A 15-pin female TYCO connector with 15 contacts is factory-terminated so the cable mates directly with the drive carrier. The PUR outer jacket provides oil and coolant resistance, and an insulation level of ≥500 MΩ·km limits leakage current during continuous flexing. For energy-chain applications, the cable can travel at up to 300 m/min without exceeding thermal or mechanical limits.

A dynamic acceleration capacity of 50 m/s² allows rapid carriage movement, and the design endures 5,000,000 flex cycles before conductor fatigue becomes critical. During installation, the moving bend radius must stay above 150 mm to avoid crushing the layered structure, while a power line resistance of 8 Ω/km keeps voltage drop low over typical machine lengths. The assembly operates on circuits up to 1000 V, and its molded backshell is intended for fixed cabling rather than frequent disconnects because it is rated for 20 mating cycles. An IP65 rating seals the connector against dust and low-pressure water jets, supporting decentralized drives mounted outside control cabinets.