Product Description:

The 8CCH0013.11230-1 hybrid cable is produced by B & R Automation as part of the 8CC ACOPOSremote Hybrid Cables series. It integrates servo power, logic power, and real-time Ethernet pairs in a single jacket so one cable run can serve an ACOPOSremote drive from the control cabinet. Factory-installed 15-pin female TYCO connectors on both ends simplify installation, and the housings are rotated 180° to match the drive’s mating orientation. This design minimizes panel space while maintaining signal integrity between decentralized motion axes and the central controller.

The copper core mix follows a conductor arrangement of 2x2x0.34 + 4x0.75 + 5x2.5 mm²; the smaller pairs handle Ethernet and logic power, while the larger cores transfer drive current. Power conductors can carry up to 1000 V, and data pairs remain isolated for a maximum of 100 V, letting one cable serve both supply classes. For drag-chain use, the cable supports a peak acceleration of 50 m/s² and a maximum travel speed of 300 m/min, allowing high-dynamic gantries to move without overstressing the insulation. A tinned copper braid with foil shielding blocks EMI, and the PUR outer jacket resists oil and weld spatter. The assembly is rated for 20 mating cycles.

Mechanical life is supported by a flex rating of 5,000,000 reciprocating cycles, provided the moving bend radius stays above 150 mm. Insulation reliability is backed by a minimum resistance of 500 MΩ·km, limiting leakage on long cable runs. The molded backshells, gasketed coupling nuts, and PUR sheath together achieve an IP65 ingress rating, so the cable withstands coolant splash and dust in machining cells. The connector layout supports stable pin alignment, and the shield configuration helps preserve signal quality over the full drag-chain stroke.