Product Description:

The 8CCH0012.11130-1 hybrid cable is produced by B & R Automation as part of the 8CC ACOPOSremote Hybrid Cables series. It is designed to link decentralized ACOPOSremote servo drives to the control cabinet, carrying power, signal, and high-speed data within a single routed line. By combining these channels, the cable simplifies wiring in automated cells, shortens installation time, and supports modular machine layouts that rely on distributed drive technology. Its hybrid layout eliminates separate motor, encoder, and fieldbus cables, reducing carrier mass and potential points of failure.

The assembly has an overall diameter of 14.6 mm ±0.4 mm, permitting placement in standard drag-chain separators. At the drive end, a 15-pin female TYCO connector provides all fifteen contacts needed for combined transmission. Five dedicated power cores with a cross-section of 2.5 mm² deliver phase and DC-bus energy, while four data wires rated at 0.34 mm² route real-time Ethernet signals to the servo electronics. The outer sheath uses PUR, which resists chemicals and supports continuous torsion without cracking. A four-layer internal filler helps maintain pair geometry and keeps the different conductor groups properly separated inside the cable.

For dynamic motion axes, the cable endures up to 5,000,000 cycles in cable-carrier flex profiles while maintaining conductor integrity. The mated connection reaches IP65, so dust and low-pressure water jets cannot reach the live circuits. Electrical safety is supported by an insulation resistance of 500 MΩ*km, which limits leakage over long runs, and by a braided shield with >85% coverage that suppresses electromagnetic noise. Four signal conductors of 0.75 mm² handle brake release and auxiliary I/O, and the consistent core lay helps reduce crosstalk between the power, data, and signal groups.