Product Description:

B & R Automation supplies the 8CCH0007.11130-1 hybrid cable as part of its 8CC ACOPOSremote Hybrid Cables series. The cable combines power conductors, signal pairs, and real-time data lines in a single assembly, simplifying the connection between an ACOPOSremote drive and its distributed modules. In automated cells, this consolidated wiring reduces cabinet penetrations, maintains shielding continuity, and streamlines routing when daisy-chaining remote I/O or servo axes. The factory-installed connector also removes the need for on-site terminations.

The interface side of the cable terminates in a 15-pin female TYCO connector, so it mates directly with the matching bulkhead connector on the remote module. An enclosure rating of IP65 helps the mated connection resist dust ingress and low-pressure water jets, allowing routing outside the cabinet in moving machine sections. Power transmission is handled by five cores with a cross-section of 2.5 mm², which supports branch currents used on the ACOPOSremote power bus. Four insulated data conductors of 0.34 mm² are twisted for noise immunity and are rated for data potentials up to 100 V maximum; they carry the real-time Ethernet needed for synchronized motion control. The assembly is approved for system voltages up to 1000 V maximum, so insulation spacing is suitable for typical three-phase supplies.

Long-term insulation integrity is supported by a minimum insulation resistance of 500 MΩ·km, which helps limit leakage during extended machine operation. The connectors are rated for 20 mating cycles. The four signal conductors for encoder feedback use wires of 0.75 mm², providing lower impedance for differential reference voltages while still fitting within the cable structure. With five dedicated power lines segregated from signal layers by a PUR jacket, the cable maintains bending performance in drag chains and resists cutting oils commonly found in CNC environments.