8BVE0500HW00.000-1 B & R Automation
Wake Industrial LLC is not an authorized distributor of this product.
The B & R Automation 8BVE0500HW00.000-1 is part of the 8BVE ACOPOSmulti Drives series and features a DC bus nominal voltage of 750 VDC with two DC bus cable outlets. This drive measures 53 mm wide by 317 mm high by 263 mm deep and comes with an IP20 protection rating. It supports a maximum power consumption of 5 W, a power dissipation of 200 W, and a max module distance of 5 meters.
Internal Product Review
The 8BVE0500HW00.000-1 is a B & R Automation ACOPOSmulti drive module built for controlled DC bus operation with a 750 VDC nominal bus and IP20 protection. Dual DC bus cable outlets and a 3 ms switching delay support clean integration and responsive system behavior. A well-executed module for demanding panels, highlighted by efficient 200 W power dissipation.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 8BVE0500HW00.000-1 supply and monitoring module is produced by B & R Automation as part of the 8BVE ACOPOSmulti Drives series. It fits into a common backplane to distribute DC-bus energy and 24 V auxiliary power, forming the electrical spine of multi-axis servo systems used in industrial automation. By routing the shared bus and furnishing status contacts, the unit allows a central rectifier to feed several inverters while giving the controller immediate feedback on operating states. This arrangement reduces the need for separate point-to-point power wiring between drive sections and keeps the axis group organized within one mechanical assembly.
The electronics are powered through a logic input of 25 VDC ±1.6%, and two 24 VDC cable outlets forward this regulated voltage to adjacent modules. The shared DC bus operates at a nominal 750 VDC and is exposed on dual terminals that fall under Overvoltage Category III for fixed industrial wiring. An enclosure rating of IP20 means the housing is finger-safe but not sealed against liquids, so the device mounts inside a control cabinet. Internal semiconductor losses reach 200 W, and the integrated safety relay opens the bus within 3 ms after a stop command. The shutdown path supports fast fault isolation when downstream axes must be de-energized quickly. Cabinet planning is simplified by a 53 mm width, 263 mm depth, and 317 mm height, which match standard panel layouts.
Additional service connections aid diagnostics and daisy-chaining. The alarm relay can switch up to 1 A at 30 VDC, delivering isolated fault signals to a PLC. For the auxiliary 24 V supply there are 2 cable outlets, and the same count applies to the DC-bus pass-through, so neighboring modules receive power without external splitters. Communication between this module and the next drive section may span 5 m when approved hybrid cables are used. With a self-consumption of only 5 W, the unit adds minimal load to the control supply. The layout also reduces the number of separate power jumpers needed inside the cabinet while keeping fault signaling available to higher-level control hardware.
