Product Description:

The 8BCM0006.1034C-0 cable is produced by B&R Automation within the 8BC ACOPOS Cables series. It is a pre-assembled hybrid power and signal lead that links ACOPOS servo drives to their corresponding motors or control modules in industrial automation lines. By combining four power conductors with two shielded signal pairs in a single assembly, it simplifies routing tasks inside cabinets and drag-chain layouts while maintaining clear separation between supply and feedback circuits. The combined format also helps keep moving cable bundles compact in machines where installation space is limited.

The assembly is delivered in a fixed length of 6 m, eliminating the need for on-site cutting or terminations. A factory-molded 8-pin female Series 915 power connector is fitted on one end; four contacts handle the 24 V and 48 V supply rails while four smaller pins carry feedback signals. Each power core has a cross section of 0.75 mm², giving adequate ampacity for typical ACOPOS module loads. The paired encoder and communication conductors use a finer cross section of 0.34 mm² to minimize cable diameter and capacitance. A tough outer sheath of PUR resists oil, abrasion, and constant flexing, making the cable suitable for dynamic machine layouts and repeated motion cycles.

When the mating connector is locked, the interface attains a protection level of IP66/67, ensuring dust-tight sealing and temporary immersion resistance along processing lines that undergo washdown. The conductor insulation withstands a wire-to-wire test potential of 4 kV, confirming dielectric integrity for low-voltage motion systems. The signal conductors are arranged as individually shielded pairs, reducing crosstalk from inverter switching edges and nearby actuators. The finished assembly weighs only 0.53 kg, so cable carriers experience minimal additional load even on long stroke lengths and repeated reciprocating motion.