Product Description:

The 80CM01001.21-01 cable assembly is produced by B & R Automation within the 8BC ACOPOS Cables series. It is a five-conductor power lead intended to connect ACOPOS servo motors to their drive modules in automated machinery. By combining dedicated power conductors with overall shielding, the cable maintains electrical integrity during repetitive motion in gantries, pick-and-place units, and other high-cycle industrial axes. Its flexible layout also suits routing through moving machine members where repeated bending and electrical noise are common.

Each conductor in the cable has a cross-section of 5x 0.75 mm². This size supports a continuous current load of 13 A without excessive temperature rise. Mechanical endurance is supported by a flex life of at least 3,000,000 cycles, so the cable can travel inside drag chains for long production runs. When the cable is in constant motion, a moving bend radius of at least 85 mm helps reduce conductor fatigue, while a static single-bend radius of 34 mm applies when the cable is fixed in place. The shield braid covers more than 85% of the circumference to reduce electromagnetic interference from nearby inverter leads. A PUR outer jacket resists oil and abrasion, and a sealed 4-pin male motor connector mates directly with standard ACOPOS motor receptacles.

In dynamic track applications, carrier speed can reach up to 4 m/s, and acceleration remains below 60 m/s² to limit internal stress during motion. Electrical integrity is supported by an insulation resistance of more than 200 MΩ/km, which helps minimize leakage at drive voltages. The copper bundle has a power-line resistance of up to 29 Ω/km, helping keep voltage drop low over typical machine lengths. Dielectric strength is verified by 3 kV wire-to-shield and wire-to-wire tests, which support safe insulation spacing within the compact cable geometry.