Product Description:

B & R Automation’s 8B0P0110HW00.000-1 belongs to the 8B0 ACOPOS Multi Power Supplies series. It is installed in control enclosures to distribute low-voltage auxiliary energy to servo drives and I/O nodes, supporting the control electronics that keep axes, sensors, and safety-related logic active during machine operation. The module accepts protective low voltage on its input side and passes it along the system backplane, ensuring a stable logic supply for coordinated machine functions while reducing the need for separate auxiliary wiring between neighboring modules.

The electrical interface starts with a single 1 x 24 V input that feeds the internal bus, simplifying wiring and limiting voltage drops across the auxiliary supply path. An integrated line filter is fitted ahead of the bus conductors to attenuate conducted noise, which helps nearby drives and control electronics operate with less electrical interference on shared cabinet wiring. Two Ethernet-based communication sockets are provided and are designated as 2 Powerlink ports, allowing ring or daisy-chain network topologies to pass through the power section without requiring a separate switch module at this location. Under continuous load, the module can source 11 A rated current, so connected logic-powered devices must remain within this available output capacity.

The hardware is identified as a passive power supply, which means no active power factor correction or voltage conversion stages are present on the board and the unit mainly distributes incoming auxiliary power. Mechanical fixation relies on wall mounting, so the housing clips directly to the rear panel of the cabinet without occupying DIN rail space and can be positioned near the associated drive group. Status information is emitted through a green 24 V status LED that confirms bus presence, while a green/red ready/error LED beside the network jacks shows whether the unit is ready or reporting a fault condition.