8B0C0160HC00.000-1 B & R Automation
Wake Industrial LLC is not an authorized distributor of this product.
The 8B0C0160HC00.000-1 is a power supply from the 8B0 ACOPOS Multi Power Supplies series by B & R Automation. It provides a continuous power output of 400 W with a continuous current of 16 ADC and supports a DC bus nominal voltage of 750 VDC. The unit allows for cold plate or pass-through mounting and features an IP20 protection rating.
Internal Product Review
The 8B0C0160HC00.000-1 is a B & R Automation ACOPOS Multi power supply with 400 W continuous power and 16 ADC continuous current. Cold plate or pass-through mounting and IP20 protection support clean, serviceable integration in control cabinets. A 750 VDC nominal DC bus gives the unit strong compatibility for high-performance motion systems.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 8B0C0160HC00.000-1 is a DC-link power supply module manufactured by B & R Automation for the 8B0 ACOPOS Multi Power Supplies series. It converts three-phase mains energy into a regulated 750 VDC bus that feeds multiple ACOPOS Multi servo inverters, allowing coordinated axis control on a common rail. By integrating line conversion, energy buffering, and protective monitoring in one housing, the unit simplifies cabinet layouts and supports compact machine designs in industrial automation.
The supply delivers a continuous output of 400 W while sourcing a steady 16 A DC to the DC bus; for short load transients under four seconds, it can supply up to 21 A DC. Its nominal bus voltage is 750 VDC, stabilized by an internal 220 nF film capacitor that filters high-frequency ripple. During startup, the control electronics enable the output after a maximum delay of 1 s, ensuring predictable sequencing with downstream drives. Maximum sustained input demand is limited to 445 W, and the feedback terminals tolerate up to 26 VDC to protect sensing circuits. The assembly is rated for Overvoltage Category III, so it can be wired in fixed plant installations exposed to distribution-level surges.
Mechanical and environmental parameters match typical control-cabinet conditions. Cooling is achieved through a cold plate or pass-through mounting surface that transfers heat directly to a panel or machine frame. The aluminum enclosure is 317 mm high and only 53 mm wide, permitting dense stacking of multiple supplies. An ingress protection level of IP20 is provided when installed inside a closed cabinet. The device operates reliably up to a surrounding temperature of 55 °C without derating and can be installed at elevations as high as 4000 m above sea level, maintaining specified clearances and creepage distances under reduced air pressure.
