0GH-AI375 B & R Automation
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The 0GH-AI375 analog input module offers 8 channels, a 12-bit resolution, an input range of 4–20 mA or 0–10 V, and channel-to-bus isolation rated at 1500 V AC for 1 minute. From the 0GH PLC Modules series by B & R Automation, it has a compact size of 25 x 100 x 100 mm and a power consumption of approximately 3 W.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
This 0GH-AI375analog input module designed by B & R Automation converts the measured current and voltage to their corresponding numerical values for processing by a PLC. The module has a standard design. This product needs a terminal block for operation. The device is engaged in the acquisition of analog signals from a variety of field systems such as sensors and transmitters. This unit comprises eight differential inputs. It is cULus Recognized. The module deploys a successive approximation conversion procedure.
This product has one normal operation mode and two special operating modes. The device features RUN and MODE status LEDs. This unit has 20 pins in its design, including four pins for shielding. It uses shielded cables for its connection. The module’s shielded connections are connected to the ground through 100-ohm resistors. This product portrays electrical isolation with the PLCs. The device portrays single-width dimensions. This unit’s nominal operation mode is set automatically when it is powered on. Its converter value changes in increments of 16.
The module depicts a 12-bit digital converter resolution. This product’s design comprises a 1st order low-pass input filter with a cut-off frequency of 450 Hz. The device’s data points are directly accessed using a variable name in the application program. This unit features a +/-10 V input signal. It also has a total power consumption of 4.5 W and a repeat precision of +/-0.025%. The analog input module supports a change in operating mode at any point in time in the operation period by setting the mode register 2 to the desired value.
