The AL2403-0001-0000 is a synchronous linear servomotor from BeckhoffAutomationGmbH. The servomotor is a good choice for tight installation situations. The three-phase product has an S type winding and features high current consumption and maximum speed. The motor is one of the several AL2400 series of devices of its kind from the manufacturer. It must be used only in electrical machines or systems. The unit must not be used in ATEX zones if it does not have proper housing. The user operating the motor should not wear gloves that have a rubber coating. The device comes with a one-yearwarrantyperiod.
The surface of the linearmotor may reach temperatures of more than 50°C during operation. The DC link terminal points may have dangerous and high voltages even after disconnection from the mains supply because of the DC link capacitors. The device encompasses permanent magnets in its magnetic plate. The unit has a velocity of 12m/s and a magnet pitch of 24mm. It can be used along with the AX5000 digital EtherCAT servo drive from the manufacturer, for dynamic movements that need high acceleration over short distances. The motor has a width of 51mm.
The synchronous motor has a low thermal resistance of 1.5°C/W for high capacity utilization. The product features a voltage rating of 400 to 480VAC. It must be stored in a dry and ventilated place at a temperature between-25°C and +55°C. The brushless device should be checked for the proper functioning of buffers and bearings. The housing must be cleaned with isopropanol or a similar substance. The device must be installed below an altitude of 1,000m above sea level. The unit encompasses a potted coil unit with IP 64 protection rating. We can ship the motor to any address through our trusted vendors.
Wake Industrial sells new surplus and reconditioned products. This website is not sanctioned
or approved by any manufacturer or tradename listed. Wake Industrial is not an authorized
distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands
appearing herein are the property of their respective owners.
Copyright 2020 - Wake Industrial - All Rights Reserved