Product Description

The BL-MC300J-12S is a BL series servo motor from Okuma. The AC voltage for which the motor is designed is three-phase 141 Volts. The AC frequency for which the motor is designed is 80 Hertz. The AC input current for which the motor is designed is 14.7 Amps. The BL-MC300J-12S gets the electrical power input from a connected servo drive controller. The BL-MC300J-12S includes an integrated encoder for feedback. The feedback from the encoder is transmitted to the drive controller via a dedicated feedback cable. The operating speed for which the BL-MC300J-12S is designed is 1200 RPM. The nominal output power rating of the BL-MC300J-12S motor is 3.6 kilowatts. The motor and associated equipment should only be handled and installed by qualified personnel. The relevant installation instructions are included in the product documentation.

The safety and installation instructions should be read and understood by the personnel involved in motor installation and operation. The continuous stall rating of the BL-MC300J-12S is 31.5 Nm. The motor is constructed from permanent magnets. The motor is checked prior to delivery. The motor should only be used as intended. If the BL-MC300J-12S is not used as intended, situations may arise that result in injuries to persons and property. Okuma does not permit any modification to the motor hardware. Okuma also does not permit any decompiling of the motor firmware. If a motor is damaged, it should not be put into operation. The motor should be installed, operated, and serviced according to the regulations and environmental conditions that are specified in the documentation. The motor should only be used with approved accessories. Use of un-approved accessories will adversely affect motor performance.