Product Description
The RD51.1-5B-075-W-V1-FW vector control offered by Bosch Rexroth has a rated current of 108A. The control comes with A1 noise immunity. The product incorporates an inbuilt chopper. The device must be assembled at right angles to a level construction area. Its installation is to be done in a dust-free place. The unit is designed to be stored between -25°C and 70°C. This control should not be used when there is extreme temperature fluctuation. The product must also never have condensation on its surface. The device has chance of getting damaged if it is put to inappropriate use. The unit is designed to be used only with spare parts and accessories approved by the manufacturer.
The vector control must be allowed to start only if the machine in which it is installed is in compliance with the safety specifications pertaining to the application. The product is not intended to be used in refinery plants, hoisting equipment, cranes and the like. This device must be worked on only after five minutes of turning OFF the power so that the capacitors get discharged fully. The unit is equipped with 75kW rated power. Its output frequency ranges from 0Hz to 250Hz. The product features a cooling air requirement of 0.4m3/s. The control is delivered to your address in custom military-grade packaging through a reputed vendor network.
The device encompasses IP 20 degree of protection without its connection terminals according to EN 60529 specifications. The unit has to always be secured against direct contact. It can show signs of dangerous movements at any point of time during operation. The vertical axes of the drive associated with this product have to be secured against falling after switching OFF the motor with which it is connected. The electric power to the control should permanently be disconnected using a master switch when it is being cleaned, maintained or repaired. Its heatsink and resistors become very hot when it is in use. The vector control has warranty support for one year from Wake Industrial.
