Product Description

The MCS020-3S-0300-NNNN coreless secondary part manufactured by Bosch Rexroth features a 020 size code. This secondary part must be checked for cleanliness before it is mounted. The part supports connectivity to the machine in two different ways. The product may cause damage to the associated motor if there is no sufficient air gap between the secondary and primary parts. The accessory portrays a drilling diameter of 4.3mm. The unit must not have any scratches on its surface. Its installation direction does not have any impact on the encoder polarity setting. This part depicts a U-shaped design. This product has to be positioned parallel to the primary part of the machine.

This accessory tends to make contact with the primary part present in the motor if there is an undersized air gap. The unit has an overall length of 299.7mm. Its frame size is based on the length of its motor. The secondary part has a coating on its permanent magnets for protection against external influences and to offer the best operational reliability. It has to be connected with the potential of its protective conductor if the grounding cannot be done as needed. The accessory has no magnetic shielding. The unit belongs to Category I, Category II or Category III for transport.

The secondary part can result in an attractive force and reduced feed force if it is only partially covered. The product must never be used continuously in the partially covered state. This part is designed such that a polarity reversal arrangement of multiple accessories within a path cannot be done.  It is to be ensured that the position offset between two secondary parts is less than 1mm in the feed direction for the successful operation of the motor. The secondary part features one-year backup support and is shipped to the desired address through reputed freight carriers.