Product Description

The KDS 1.1-100-300-W0 servo drive from Bosch Rexroth works in conjunction with the manufacturer's MAC series of motors in a drive control system. This drive has a current rating of 100 A. The product comprises an inbuilt external heat exchanger. This device is designed exclusively for industrial use. The unit is prone to damage because of incorrect handling. It does not cause any heat losses inside the control cabinet when it is being used. This drive can be made to function like a torque-controlled drive. The product should be properly earthed at the appropriate connecting points before it is put to use. This device encompasses a potentiometer in its set-point input. The unit has an IP 20 protection rating. It also encompasses a differential input with a voltage ranging from -10 V to +10 V. This drive can be used along with other servo drives from the manufacturer. The product must have its programming module already plugged in at the time of its start-up. This device supports a bus connection at its X1 connecting point. The unit portrays a reduced out when the maximum ambient operating temperature is exceeded. It supports cold-running technology. This drive is cooled by natural convection. The product is mounted onto the control cabinet using a mounting frame. This device should have sufficient clearance above and below it inside the control cabinet where it has been mounted. The unit should not have any heat-producing parts installed under it. It has a mass of approximately 15.2 kg. This module should encompass an adaptor board with a connecting terminal for its thermostat contact to enhance immunity to interference.