DDC01.1-K150A-DA07-00/S001

MPN: R911260137

  • Straightforward Pricing: No Rush Fees, No Credit Card Fees
Ask for Availability

Preparing your secure checkout page...

The DDC01.1-K150A-DA07-00/S001 Servo Compact Controller is manufactured by Rexroth Indramat Bosch. This controller has a Air, Natural Convention cooling type, a rated current of 150 A and a Standard (50 A? 200 A rated current) Noise Emission at Motor. This DDC Controller has a(n) ANALOG Command Module.

Warranty
Wake Industrial Warranty
To contact sales for pricing and lead time:

Payment Methods

Visa
Mastercard
AmEx
Wire Transfer

Shipping Methods

DHL
UPS
FedEx
Freight

Our Credentials

Cary Chamber
DUNS Registered
SAM Registered
BBB Accredited

Product Description:

The DDC01.1-K150A-DA07-00/S001 Bosch Rexroth servo drive is a three-phase current drive. This servo drive supports a maintenance-free operation. The bleeder resistor of the product becomes very hot during operation. The air outlet of the device has to be at a minimum distance of 300mm from flammable parts or materials. The optional plug-in modules and motor feedback cable of the unit are connected on its underside. These connections should be done properly to maintain its IP 65 protection category. The drive must be installed vertically. The X3 connector of the device is used for analog inputs and outputs.

The servo drive has a separate rating-plate for its basic unit. The U1 to U4 slots of the unit are used to insert various plug-in cards. The U1 slot is reserved for command interface cards. The product is compatible with sequential finishing machines. The device is not susceptible to circuitry interference. Its signal lines should be grounded with shields. The MDD series synchronous motor connected to the unit can be brought to a standstill mode by dynamic braking action. The parametrization of the drive controller is possible with the help of a CTA programming and display unit.

The drive controller should not be connected to a VT-100 terminal or a PC when it is carrying a current. The CTA unit can be used to input and optimize the control and drive parameters. The controller must be applied with a 3 x 230VAC +10%-15% distribution voltage for inputting parameters. The drive wiring should be checked for breaks, short circuits, and incorrect connections before the product is turned ON. The earthing of the device must always be done in accordance with the manufacturer’s connection recommendations. The housing of the drive controller should be connected to the machine chassis for electrical conductivity. The DDC01.1-K150A-DA07-00/S001 servo drive can be sent through reputed freight carriers with a one-year warranty backup.

Command Module
ANALOG
Cooling Type
Air, Natural Convention
Noise Emission at Motor
Standard (50 A? 200 A rated current)
Rated Current
150 A
  • DDC011K150ADA0700/S001
  • DDC01 1 K150A DA07 00/S001
  • ddc01.1-k150a-da07-00/s001
  • DDC1.1-K150A-DA07-00/S001

Motion Industries logo
3M logo
IBM logo
Gexpro Logo
Caterpillar logo
NASA logo
Ford logo
Vallen logo