Product Description

The DDC01.1-K050A-DL01-01-FW Bosch Rexroth digital servo drive encompasses a positioning module with a single axis. This module can be programmed using a CTA programming and display unit. The parameters for the setup mode of the servo drive must be input only by personnel with expertise in operating the machine. The H1 display of this product highlights the “bb” code when the setup mode is ON. Its mains contactor can be turned ON if the e-stop sequence is closed and the wiring is done as per the manufacturer’s specifications. The device is intended to be started only after its parameters, as well as the DLC controller parameters, are programmed.

The leakage current of the servo drive is more than 3.5mA. The contact points of the unit are supposed to be touched only about five minutes after it is turned OFF so that the capacitors get discharged fully. Its drive controller can be set to determine how the drive must respond when an error is encountered. The drive does not come to standstill mode in case of errors such as faulty hardware synchronization or motor encoder error. This can cause damage to the machine and can be prevented by applying the DC bus dynamic brake.

The digital drive is a brushless three-phase current drive. The highlights of the product are high dynamics and precision. The device can be matched to the electrical and mechanical conditions of the machine using parameters. The unit encompasses a mains rectifier. The forward feed unit on which its controller is mounted can operate as a standalone system. The plug-in modules of the drive are fitted on its front panel. The drive controller in the configured state includes a basic unit, a software module, a DLC one-axis positioning module, an optional auxiliary plug-in module, and a configuration rating plate. We can send the servo drive with a one-yearWake Industrial warranty to the address of your choice.