The S20660VTS is a product of Danaher Motion, a world-leading producer of servo drives and other automation applications. It falls under the S200 series and comes with features such as a continuous rated current of 6ARMS, a peak current of 18ARMS, and a 120/240 VAC voltage. It also comes with a velocity and torque mode functionality mode and SDF motor feedback support. S20660VTS has a peak output current of 18.0Arms and a minimum peak current time of 3.0 seconds. The servo drive has a height of 6.90”, a width of 2.52” and a depth of 5.18”.
Vertical mounting is recommended for this drive while leaving a space of 2 inches between it and the cabinet. Since it comes in an IP20 protection category, an enclosed cabinet is ideal. The air inside should be free from dust, corrosive, and conductive gases and fluids. The operating temperature of S20660VTS is 0 to 40 degrees in full rating mode and 40-50 degrees when derated. The storage temperature is -35 to 85 degrees while its installation elevation is less than 1500 meters. Always use the AUX FB (J14) connector when using the SinCos and ComCoder motor feedback.
Only trained persons should operate S20660VTS. One should read the manual before installing and starting this servo drive. Like other S200 brushless servo drives, the S20660VTS provides high performance when in use with low power applications. Rapid start and stop action is made possible thanks to the 3-5 kHz current loop bandwidth and the 24-bit feedback. These operations significantly optimize the performance of the machine. The Danaher Motion drive should be mounted on a flat electrically conductive mounting surface connected to a Protective Earth Ground that can seamlessly support the unit.
Wake Industrial sells new surplus and reconditioned products. This website is not sanctioned or approved by any manufacturer or tradename listed. Wake Industrial is not an authorized distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.
Copyright 2019 - Wake Industrial - All Rights Reserved