COVID-19 Update: Wake Industrial is open and available to support your automation needs.

07F5B1BLBOA

  • {{ 'Rated ' + avg.toFixed(1) + ' (' + ratingCount + ' total ratings)' }}
  • {{ message }}
DRIVE 1HP 1.8AMP 440-480VAC 3PH OPEN LOOP

07F5B1BLBOA

  • {{ 'Rated ' + avg.toFixed(1) + ' (' + ratingCount + ' total ratings)' }}
  • {{ message }}
DRIVE 1HP 1.8AMP 440-480VAC 3PH OPEN LOOP

Warranty
1 Year Wake Industrial Warranty Included
Shipping
Worldwide shipping via DHL, UPS, and Fedex
Exchange
Call to find out about our exchange credit for your defective unit.
Sell Us Your Surplus
Have a 07F5B1BLBOA to sell?
To Speak to a sales representative for pricing and lead time:

Product Description

07F5B1BLBOA is a COMBIVERT F5 elevator drive manufactured by KEB. It falls under the new version of the elevator drive that offers the most dynamic and highest performance in the market. Its features enable it to carry out smooth speed regulation of three-phase motors. The 07F5B1BLBOA has an F5 unit type. 07 unit size, and a braking transistor. It also comes with a KEB elevator drive application, and you’ll have to install a feedback card since it is not installed at the factory. A 480 V nominal supply voltage powers the inverter.

To offer professional-grade services, it features noise immunity, hardware current regulation, short circuit proof, and ground-fault proof and extensive protection from over-temperature, current and voltage. It also features a direct position control, multi-lingual LCD, and direct position control. You should not use the 07F5B1BLBOA with other electrical loads since it leads to the destruction of units. This KEB F5 inverter features a software version 3.31 which comes with new parameters such as LC36 Full Load Torque, and LC35 no-load torque, which is to be used with CAN open lift only and LX25 unintended motion distance.

The 07F5B1BLBOA should be mounted on a fixed location far from vibration, and if the installation is on a moving system, then unique earth ground connections are paramount. For high-frequency grounding, a bare metal sub-panel made of zinc-plated steel is recommended. The IP 20 protection category requires the F5 inverter to be mounted in a cabinet controller. The air inside the cabinet should be free from corrosive and conductive gases. You should not expose it to fluids either. For extended life, prevent dust from entering the cabinet.

  • 07.F5.B1B-LBOA