Product Description

The DKR03.1-W200N-BE09-01-FW is one of the DKR drive controllers manufactured by Bosch Rexroth. This drive controller makes use of a digital servo and resolver feedback for the motor connected to it. The drive must be brought to a standstill position before accessing the danger zone. This controller must be disconnected from electrical power with a master switch when it is kept unused for a long period. Its housing, resistors, and heatsink can become very hot during operation and can cause burns if touched during this time. The device should be handled using only appropriate tools. The unit is compatible with the manufacturer’s ADS, 1MB, and ADM series of motors.

The drive controller must not be assembled or disassembled in the pressurized state. This product helps to digitally control the manufacturer’s motors that have a continuous power output of 10kW to 93kW at the motor output shaft. The drive supports a wide speed range with constant power and a high level of control. The device is fitted with an emergency stop shutdown system and a mains contactor. The basic unit of the controller can be fitted with plug-in cards in its U1 to U5 slots. The firmware comprises the operating software of the controller.

This device can be integrated with a brake resistor if needed. The unit supports an ideal operating temperature range between 5°C and 45°C. It has a total heat dissipation of 1,200W. The product may get damaged due to overloading or if it is used in non-ambient conditions. The device encompasses a maximum pressure rating of 160Pa and a minimum air flow of 300m³/h. The external and internal energy dissipation is dependent on the load applied. There must be a minimum gap of 80mm above and below the controller inside the closed housing that it is mounted in. The drive controller with a one-year warranty can be shipped internationally.