Product Description

The DDS02.1-W025-DS03-00 drive controller manufactured by Bosch Rexroth tends to have high electrical voltage due to incorrect connections. The product must be checked to see that it is in standstill mode prior to entering the danger zone. The device has four slots at the bottom to insert the plug-in modules. The software module is inserted at the top slot. The power section of the unit has a DC bus voltage of 300V +/-15%. The controller is designed to support a maximum installation elevation of 1,000m over sea level with rated data. Its load capacity depends on the installation elevation and ambient temperature.

This drive controller is not designed to support protection against intentional access by hand. The drive with excessive current levels and high output must be placed close to the supply unit when multiple drives are placed adjacent to each other. The cool air enters the product through the bottom during operation and hot air gets discharged at the top. The connections of this device have to be removed if interference or high voltage test has to be performed to avoid any damage to its electric components. This controller can be delivered to any address irrespective of the country you live in.

The analog signals of this product are to be routed through shielded leads. The shields must be mounted onto the controller. The X6 connector of this device helps in monitoring the temperature of the connected motor. The unit can be connected to a PC or a VT-100 terminal through an RS-232 interface. Its power cable encompasses one line for the protective conductor connection and three lines for the motor power connection. The X1 connector of the product supplies its required control electronics. The unit utilizes the E-DDS2 electrical connecting accessories kit to simplify the connection. This DDS02.1-W025-DS03-00device is available with a one-year warranty.