Product Description

The Rexroth DDC01.2-N200A-DL04-01-FW is a servo drive with IP 65 rated enclosure. It measures 517 x 165 x 298 millimeters and needs to be mounted in the vertical orientation. The motor power connection is located on the bottom side of the drive. The interface to the NC control of machine and mains connection are also located on the bottom side of the drive. A configuration rating place it installed on the top side of the front panel. The slot for the firmware module is located next to the rating plate. Four additional slots are located below the rating plate. One of these slots is used for installation of a command module and the remaining are used for plug in modules. The command module on the DDC01.2-N200A-DL04-01-FW is a single axis positioning module. Also located on the front panel of the drive are a reset key, a serial interface for interfacing with a programing PC and an interface for the motor feedback connection.

A digital servo on the DDC01.2-N200A-DL04-01-FW enables motor feedback. The drive is rated for standard noise emission at the motor. The power terminal connectors, the motor power terminal and the NC control unit interface are rated for IP 65 protection category. The motor feedback cable and the connections for the plug in cards are inserted in to the DDC01.2-N200A-DL04-01-FW. These cables are run through the cable lead-through along the underside of the servo drive. The cables must be inserted carefully to maintain the IP 65 rating. Peak output current ring of the DDC01.2-N200A-DL04-01-FW is 200 Amps. The permitted relative and absolute relative humidity levels are 95% and 25 grams of water per m³ of air respectively. This unit can be shipped globally with a one-year warranty period from Wake Industrial.