Product Description

The DDC01.1-K200A-DL04-00 drive produced by Bosch Rexroth features a mains contactor. This mains contactor can be turned ON if there is a closed E-stop sequence and the wiring is in accordance with the manufacturer’s terminal connecting diagram. This drive has a version code of 1. The product can function as a positioning controller with just one axis when it is used in conjunction with the positioning module equipped with one axis. The input/output interface that is connected as a plug-in module features multiple inputs and outputs. These inputs and outputs can be used for exchanging binary signals, signaling the fault messages and more.

The female and male connectors of the positioning module fitted to the drive can be connected to programming and display unit and a RS 232 or a RS 485 interface. The H1 display highlights the “bb” message if the setup mode is ON and there are no faults. The product must be used only in the combinations specified by the manufacturer. The motor connected to the device features digital servo feedback with or without multiturn encoders. The heatsink and blower mesh of the unit tend to become extremely dirty if operated in a highly polluted environment.

The bleeder resistor of the servo drive tends to get heated up during operation. The air duct of the unit should be at a distance of at least 300mm from flammable objects. Its motor power connector and interface to its machine control must encompass IP 65 connections. The U1 slot of the drive is used to insert the command interface card. The X2 connector of this product features RS 232 interface connection to connect a PC or a VT-100 terminal. This DDC01.1-K200A-DL04-00 servo drive with a one-year backup offering is eligible for global shipping.