Product Description

The DDC01.1-K150A-DS46-00-FW is an intelligent DDC series 1 drive produced by Rexroth Indramat for use with AC servo motors. It comes with slots for plug-in modules and software module. There is also a port for mains connection and an interface for connection to drive controller. It links to the designated AC motor via a motor power cable and motor feedback cable. The feedback mechanism utilized by the DDC01.1-K150A-DS46-00-FW is the digital servo type. At 100 – 200 Amperes rated current; a standard noise emission is experienced at the shaft of the connected motor. The function code of this model is 46, and it has a code version of 00.

During acquisition, the firmware of the DDC01.1-K150A-DS46-00-FW is to be purchased as a separate item, exclusive of the drive unit. This unit features a bleeder resistor that generates a lot of heat during operation. During installation, the DDC01.1-K150A-DS46-00-FW must be kept at a minimum clearance of 300 mm from combustible materials or substances/parts that are susceptible to deformation when subjected to a hot air stream. Also, all air outlet must be obstruction-free to facilitate efficient cooling and temperature management.

When installing the plug-in cards and motor feedback cables, care must be taken to maintain the Ingress Protection category of the DDC01.1-K150A-DS46-00-FW servo drive unit. The discharge current of this device is dependent on the dimension of the motor power cable, motor type and the prevalent ground and ambient conditions at the site of use. At the X8 connection point on the DDC01.1-K150A-DS46-00-FW, 15 V and 24 V can be tapped off for test and measuring purposes. For safety purposes, this device is best suited for use in industrial areas. This unit can be shipped globally with a one-year warranty period from Wake Industrial.