Product Description

The DDC01.1-K150A-DS01-02-FW servo drive produced by Bosch Rexroth has a rated current of 150A. The product has a standard noise emission at the motor end. The firmware of this device must be procured as a separate subitem. The unit requires minimal maintenance for its operation. Its heatsink and blower can become very dirty if the drive is used in a highly polluted environment. This can affect the operation and hence they must be cleaned if found to be dirty. The air duct of this product must always be at a minimum 300mm distance from flammable parts or materials that can get affected by the hot stream.

The servo drive has a size of 657.5mm with the blower and 517.5mm without the blower. The U1 slot of the device is used to connect the command interface card while the U2, U3, and U4 slots support the auxiliary plug-in modules. The ground connection of its signal lines must be done after shielding them. The device is braked in a regulated manner by its electronics at maximum torque if the machine housing it is shut OFF or the emergency stop is activated. The 9-pin male connector of the integrated positioning module helps in establishing connectivity with a RS 485 or RS 232 interface.

This drive can be connected with an interbusS data highway using a DBS 2.2 interbus S interface module. The information mentioned in the configuration rating-plate of the product helps to identify a replacement for the defective part. The power cables must cross the signal and control leads at an angle of 90°. The drive load can be checked by measuring the current of the connected motor at feed velocity during acceleration and in rapid traverse. The basic unit incorporates a mains section for its control voltages. The DDC01.1-K150A-DS01-02-FW device with a warranty tag for one year can be sent to any address globally.