Product Description

The Bosch CSH01.1C-SE-ENS-EN2-MA1-S2-S-XP-FW is an advanced single-axis control unit. It is one of two main components that make up an IndraDrive controller. The other main component is a power section on which the control unit mounts. The control unit mounts vertically on the power section. The input voltage rating of the control unit is 24 volts DC. The power consumption of the basic unit of the control unit is 7.5 Watts. The value of the typical inrush current is 4 Amps and the maximum pulse width is 100 milliseconds. The SERCOS master communication interface draws 1 Watt power from the power section. The encoder IndraDyn module installed on the control unit draws 6 Watts power from the power section. The encoder EnDat 2.1 module installed on the control unit draws 6 Watts power from the power section.

A standard control panel, if connected to the CSH01.1C-SE-ENS-EN2-MA1-S2-S-XP-FW, draw 1 Watt power from the power section. This type of control panel is not hot swappable. A safety module that support safe motion is also installed on the CSH01.1C-SE-ENS-EN2-MA1-S2-S-XP-FW. The analog I/O extension module installed on the CSH01.1C-SE-ENS-EN2-MA1-S2-S-XP-FW draws 2 Watts power from the power section. This module supports two differential analog inputs and two analog outputs. The input and outputs are rated for ±10 Volts. The input and output channels support 12-bit resolution. The control unit firmware is ordered as a separate subposition. It can be identified by the firmware type plate that is attached to the CSH01.1C-SE-ENS-EN2-MA1-S2-S-XP-FW. Separate type plates for the control unit and power section are also attached to the unit. The purpose of these type plates is to assist with equipment identification. The information on the type plate must be verified at the time of equipment delivery.