Product Description

The CDB01.1C-SE-ENS-ENS-NNN-NNN-L1-S-K1-FW basic universal control section offered by Bosch Rexroth incorporates two axes. This product should be put to use only with drive controllers from the same manufacturer. The device supports connection only with the manufacturer’s cables. The unit is not recommended for usage in residential areas with a public low-voltage mains supply. It must be properly and correctly mounted, installed, stored and transported for safe and optimum operation. This control section has to be commissioned only if the machine in which it is installed adheres to the safety standards and specifications as well as national regulations pertaining to the application.

The product is meant to be touched only after half an hour of turning OFF the power supply so that the capacitors get discharged fully. Its electrical connecting points should never be touched when there is an active power supply. The device should be disconnected from electrical power and secured against reconnection using a master switch during cleaning, repair and/or maintenance work as well as when it is kept unused for a long period. The unit has two-position control and velocity control cycle times. It portrays a starting lockout mechanism at its X41.1 and X41.2 connectors. This CDB01.1C-SE-ENS-ENS-NNN-NNN-L1-S-K1-FW basic universal section features warranty backup for one year and is dispatched in durable packaging.

The device must encompass a signal source with the lowest impedance possible at the ia1 analog input for a low degree of linearity error. Its relay contact features a Ready for operation factory setting. The contact depicts 1A and 24VDC nominal data. The starting lockout of the unit is in compliance with stop category 0 as per EN 60204-1 specifications. This lockout does not support bus wiring. The slot for the memory card is located below the slots for the optional modules. The analog inputs of this section have a +/-10V voltage rating and a typical resistance of 160 kiloOhms.