Product Description

The HDS04.2-W200N-HS97-01-FW drive controller offered by Bosch Rexroth incorporates a firmware that must be ordered as a separate subitem. This firmware is stored in the drive controller’s HSM software module along with the other drive parameters. The product encompasses empty slots designated as U1 to U4 in its basic unit to insert the plug-in modules. The configuration type plate of the device helps in identifying the modules associated with the controller. It has a continuous current rating of 120A/80A at 4kHz/8kHz. The unit features IP 10 protection category in adherence to DIN VDE 0470-1 / EN 60 529 specifications. The controller has chances of getting damaged due to electrostatic loads of tools and/or persons.

The signal supply lines of the drive controller must be routed separately from its load supply lines to avoid interference. The product encompasses H1 status display and an S1 fault reset key on the front panel of the basic unit. This status display highlights the warning and error messages during operation. The device also encompasses an X1 connector for connecting its power supply. Its starting lockout serves as a safety mechanism to prevent the connected motor from unintentionally starting up when there is an error. This lockout does not result in stopping the movement of the axis.

This controller has a function ID code of 97 as determined and documented by the manufacturer. The cable used by the product for motor power connection comprises three supply wires for its motor power connection, one wire for its grounded conductor connection and two separately shielded wire pairs for the motor holding brake and temperature monitor. This cable can have a maximum length of 75m. The device is fitted onto the control cabinet by means of mounting rails. The HDS04.2-W200N-HS97-01-FW controller is shipped through well-known freight carriers and features a warranty for a year.