Product Description

The DDS02.1-A200-DS01-02-FW drive controller is designed in such a way that it must always be installed in a closed housing or a control cabinet. This device from Bosch Rexroth has an IP 10 protection rating that safeguards it against penetration of solid external objects that have a diameter of more than 50mm. It features a clearance of 110mm +/-0.5mm inside the control cabinet in which it is installed. The housing may experience a high voltage rating if the earth wire is not connected before the drive controller is started. The electrical connecting points of the controller must not be touched after the unit is turned on. The drive controller features a one-year warranty offered by Wake Industrial.

The drive controller errors that cause a dangerous movement can take place at any point in time after the product is turned on. This may be immediately after the switching on action or after operation for an indefinite period. The device must be de-energized with the help of a master switch and prevented from turning on when it is being cleaned or repaired. It makes use of a SERCOS interface as its communications module. This interface is a plugin module that helps to operate the unit with compatible controls through a fiber optic cable. These cables must be ordered separately.

This DDS series drive controller has a current rating of 200A. The product must be installed within an altitude of 1,000m above sea level. The firmware must be procured as a separate subitem. The device must be operated only after waiting for five minutes after it is powered on. This is the minimum time required for the capacitors to get discharged fully. The unit must not be operated near high-frequency equipment as far as possible. The product features both firmware and hardware in its configured state. It can be shipped through reputed delivery agents like FedEX.